Vsi produkti




Gefen has designed the HDMI Detective Plus for quick and easy programming and installation. After a simple EDID recording process is completed, the HDMI Detective Plus is installed at a place in the video distribution chain where it can provide the HDMI source with a consistent EDID signal. In addition to supporting all features of HDMI 1.3, the HDMI Detective Plus is also fully compatible with 3DTV.

How It Works

To program the Detective, first connect it to the HDMI input of the display or A/V receiver that is being used. For the programming process only, the Detective is powered by an included 5V DC power supply. Disable the write protect switch, set the DIP switches to the appropriate positions, depress the program button and after a few seconds EDID recording is complete. The Detective can now be disconnected from the display and power supply and installed at the appropriate place in the video distribution chain. The Detective will receive 5V power from the HDMI output of the source device.

Note:  This device is HDCP compliant.

The supplied 5V DC power supply is only needed during the initial EDID programming step.
Once the internal memory in the HDMI Detective Plus has been correctly programmed, the power supply is no longer needed.

The Gefen HDMI Detective Plus includes 5 pre-programmed EDID profiles that can be used in the event that a suitable EDID cannot be recorded. Instructions for selecting a pre-programmed EDID profile are outlined in the user's manual.

HDMI Features Supported:

  • 225 MHz (up to 12 bit YUV 444 @ 1080p)

  • Deep Color

  • x.v.Color

  • Dolby TrueHD & DTS Master Audio

  • Lip Sync Pass-Through

  • CEC Protocol Pass-Through

Package Includes:

  • (1) HDMI Detective Plus (EXT-HDMI-EDIDP)

  • (1) 1 ft. Locking HDMI cable (M-M) (CAB-HD-LCK-01MM)

  • (1) 5V DC Power Supply (EXT-PS51AIP)

  • (1) Quick-Start Guide (QSG-HDMI-EDIDP)

Optional Accessories:

Cables for HDMI


Supports resolutions up to 1080p Full HD and 1920x1200
Programmable or can be used with selection of 5 pre-programmed EDID profiles
Write-protection switch
No power required after initial programming
3DTV, CEC and Lip-Sync Pass-through
HDCP Pass-through
Maximum Pixel Clock: 340 MHz
EDID Memory Size: 256 Bytes
Video Input Connector: (1) HDMI Type A 19-pin, female
Video Output Connector: (1) HDMI Type A 19-pin, female
Power Supply : 5V DC (for programming only)
Power Consumption: 5W (max.)
Dimensions: 2.6"W x 1.7" D x 1.2" H
Shipping Weight: 2 lbs.