All products


References


ADDERLink X-DVI PRO

Adder

AdderLink X-DVI PRO is a high performance KVM (Keyboard, Video and Mouse) extender that enables you to locate your critical computing hardware in a secure and temperature controlled environment, away from the user work station environment, whilst maintaining the same user experience. It can transmit a Single Link DVI video stream, USB 2.0 and analog audio over a single CATx cable.

Hardware compatibility

All computers with DVI-D, USB and audio - requirement dependent.

DVI-D Interface – digital only

The system supports resolutions to a maximum of 1920 x 1200 @ 60Hz.

USB 2.0 Low and Full speed

Transparent USB 2.0 (Low and Full speed) that supports HID and mass storage devices to a maximum of 50 meters. You may need to reduce maximum cable length by 5 meters if a USB hub is connected to the receiver unit.

Audio

The system delivers analog stereo audio (Line Out). 8 channels of HDMI audio are supported with sample sizes of 16, 20 or 24 bits at 32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, or 192kHz (simultaneously with the jack audio).

Software compatibility

All known operating systems.

Computer connections Transmitter (TX)

DVI-D, audio 3.5mm in, USB type B.

Computer connections Receiver (RX)

DVI-D, audio 3.5mm out, USB type A x 4.

Physical design 

Compact case, robust metal construction 120mm / 4.7’’ (w) x 75mm / 3’’(d) x 26mm / 1’’ (h) 320g / 0.7 lb.

Power

Rx: 2.5mm DC jack (power adapter included),100-240VAC 50/60Hz, 0.4A, input to power adapter, 5VDC 12.5W output from power adapter.

Tx: Powered from single USB connection.

Optional 2.5mm DC jack (power adapter not included.

Operating temperature 

0 to 40ºC / 32 to 104ºF.

Approvals 

CE, FCC.

Important extension distance details

Recommended cables are CAT7 shielded foiled twisted pairs:

Daetwyler 7702 Flexible patch cable 

Daetwyler 7120 Bulk cable

Category 5 (or better) shielded twisted pair cable must be used to connect the local and remote units in order to maintain compliance with radio frequency energy emission regulations and ensure a suitably high level of immunity to electromagnetic disturbances.

Scheme Resolution Cable Distance
WUXGA 1920x1200 CAT7 50 metres
WUXGA 1920x1200 CAT6a 50 metres
UXGA 1600x1200 CAT5e 50 metres
WUXGA 1920x1200 CAT7 40 metres

Note: Distances are achieved using single lengths of trunk/bulk cable. For each break/patch connection, reduce distance by 5m. Preferably patch cables should be of type CAT7a and less than 2m. Patch cables over 2m must be CAT7a. CAT5e is not recommended for use with this system. The maximum extension distance for USB is 50m including connections to and from the X-DVI PRO independent of cable type. If a USB hub is connected to the RX unit, this is seen as 5m of cable length. This needs to be taken into consideration when planning your system.

Additional Accessories

X-RMK-FASCIA: Rack mount plate with screws included
X-RMK-CHASSIS: Rack mount chassis